Setting up this feature was quite tricky in earlier days involving wide range of manual configuration and validation steps.However couple of manual steps are needed post deployment to enable fluid approvals.Click on the tile to check if the pending approvals page opens up.
Awe Setup In Peoplesoft Manual Configuration AndTypically following service operations are activated while performing the introspection and deployment step described above. Routing definitions between local node e.g. PSFTHR and target node WADLNODE must be activated. As this setup has proven quite tricky since its introduction, there exists quite a few discussions in Oracle support and customer forums. ![]() Approvers can access pending approvals but once they click on any request, users cannot see ApproveDeny buttons. How do I get these buttons on the approval page Do I need to create a separate Fluid Page for it or is there any configuration through which it can be achieved. I completed all the steps but clicking on mobile approval tile is launching nothing, it shows the approval image same as the one on tile. Awe Setup In Peoplesoft How To Use PageClient want to use MAP approvals as they dont have time to do peopletools upgrade which allows us to use fluid approvals but I am actually not sure how to use page composer vs MAP approvals. We have opened case with Oracle also on the another note in the demo instance I am able to see the count of the approvals now but no pending approval shows up once we click on that tile. However if i click on fluid approval tile everything shows up. Oracle suggested to switch off the Fluid approvals but so far it didnt help. However if you are on PT 8.54 and HCM image 21, then why not use page composer which was available in Image 20, instead of MAP for fluid approvals. The deleivered approval tile is not showing the count and pending approvals although if we go to classic mode it shows. I have verfied the MAP setup and Intization URL is opening with the blue page. I tried the new PUM 19 image and I didnt get an error message as you have stated. ![]() Logesh. For Activating Push Notification step we are getting error on the Transaction Registry page that Push Notification Configuration is incomplete Pardon my ignorance, but is Push Notification framework required for mobile approval to work. If Yes, can you guide us to proper documentation for push notification framework. Once you click the Approvals icon, the page is not rendering correctly. The images and not loading and contents are not aligned correctly. To find out more, including how to control cookies, see here.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |